LamboClone - The Premier Site for Lamborghini Replica Builders
How To - Tips => Electrical => Topic started by: Maxj1113 on June 01, 2013, 05:46:09 PM
-
How do you build the computer to tell the paddles to go up or down?
-
Depending the transmission you have.. i have an automatic 4t65e HD and fieroking build mine. He used an emulator.
look in the middle of the thread and u can mine.
http://lamboclone.com/index.php?topic=300.30 (http://lamboclone.com/index.php?topic=300.30)
-
There's this thing called mastershift too ^-^
-
this works if you are looking to just eliminate the shifter..
with the arduino it could be changed more to to make it an actual shift controling the shift solenoids when in "D".. and still use the actuator to control from P R N D
http://lamboclone.com/index.php?topic=232.0 (http://lamboclone.com/index.php?topic=232.0)
-
How do you build the computer to tell the paddles to go up or down?
Once you have your schematic, burn a circuit board and solder it up! The paddles dont go up and down down though :)
-
How do you build the computer to tell the paddles to go up or down?
Once you have your schematic, burn a circuit board and solder it up! The paddles dont go up and down down though :)
No up and down down? How about up up and away?
-
Correct me if I'm wrong, guys. One paddle is for "up shifting" and the other is for "down shifting". They were built for electronically controlled automatic transmissions. Jim
-
Yes , was just joking around.. The set-up I linked to and one MM uses will pretty much work with any automatic transmission, it does not have to be electronic.