LamboClone - The Premier Site for Lamborghini Replica Builders

How To - Tips => Steering / Suspension => Topic started by: farmer on July 30, 2014, 04:18:49 PM

Title: ODC-6480 naerc machine part
Post by: farmer on July 30, 2014, 04:18:49 PM

im not sure who does machine work, but im looking for somebody who can machine me this part.  its in the naerc plans  part number ODC-6480. IF anybody can machine me up a pair please pm me and we can take it from there

thanks

Title: Re: ODC-6480 naerc machine part
Post by: jdinner on July 31, 2014, 07:25:48 AM

Take the drawing and the ball joint to Satellite Welding on Costa Rd in Concord. See Ben, he is the best machinist I have ever seen.  It will cost about $100 for the pair. Oh, you do not need to make that large cut out section. It is there to install the cotter pin. If you find a ball joint with a Nyloc nut instead of a cotter pin you don't need to cut off that section.
He does need the ball joint in order to accurately measure the taper.

Title: Re: ODC-6480 naerc machine part
Post by: eddie on July 31, 2014, 11:29:07 AM

 
I had it done at Satellite too.