LamboClone - The Premier Site for Lamborghini Replica Builders
How To - Tips => Frame => Topic started by: minuteman3282 on June 09, 2016, 01:09:20 PM
-
Looking for a pic for reference on how far the dash is cut down to fit the roof for a Fiero OEM build. I was thinking along the lines of where the seem is above the vent ducting. Any help would be greatly appreciated. Thanks!
-
This is what I cut mine down to.
Jim
-
Thanks! Exactly what I was looking for! Appreciate the help and pic.
-
Heater and ductwork for defrosters. The heater area has to be trimmed to get the body to set lower. Some builders have glassed a low profile duct on the bottom of the upper dash panel to route the air flow to the outlets. Outlets similar to the OEM without the bull are available from a bus company.
-
If you are budget conscious, the vent outlets are available (oem but without the bull) from the Prevost bus company in Canada. Another option is the a/c vent from a Honda Acura. Mitsubishi Eclipse has one also but I'm not sure of the diameter. Mods to each will be required to work (as always). Jim
-
Also don't forget the defroster vents.......
Diablo 60 uses a set of 3 long defroster vents.
I have them, I also have the round vents without the bull if any one has a need for them.
If you are doing Diablo build I have bunch of stuff that are exact copy of OEM and bunch of OEM parts for the interior.
If any one wants to trade work on my car for parts.... I am all over it. I am in Central Ohio.
CCIE
yusha_2000@yahoo.com
CCIE
-
im ready to make my purchase of package you put together for me with cf panel, ty,Patrick
-
im ready to make my purchase of package you put together for me with cf panel, ty,Patrick
Patrick,
Are you ever going to pay me for the parts you purchased a while back?