LamboClone - The Premier Site for Lamborghini Replica Builders

How To - Tips => Doors => Topic started by: lambogarage on November 11, 2019, 11:52:25 PM

Title: OEM Door Hinges Dimensions
Post by: lambogarage on November 11, 2019, 11:52:25 PM

Hi, does anybody have Original Diablo/Murci Door hinges, I need some measurements.

Thanks in advance.

Title: Re: OEM Door Hinges Dimensions
Post by: 01Lambiero on November 12, 2019, 11:44:05 AM

Here are the dimensions from an oem hinge.    01

Title: Re: OEM Door Hinges Dimensions
Post by: 01Lambiero on November 12, 2019, 12:06:09 PM

I made my own hinges using 1/4" steel at the dimensions shown below.  My first set utilized the brass bushings and later I used 3/8" needle bearings.  01

Title: Re: OEM Door Hinges Dimensions
Post by: lambogarage on November 12, 2019, 04:32:44 PM

What is the width fron Side to side outside the pin area including the bushings? What are the sizes of the 2 tubing pieces where the Bushing goes in?

Title: Re: OEM Door Hinges Dimensions
Post by: 01Lambiero on November 13, 2019, 12:33:04 AM

I believe that the OEM bushings are pressed in from the outside.  The diameter depends on whether you are using 3/8" dia. hinge pin (drill rod).  They will have to be reamed to a press fit to the bore.  Use oil lite bushings.  If you press them in from the inside you will not need a washer on the inside.  The inner section is drilled for the 3/8" pin with a set screw to hold it in place.  01