How To - Tips > Frame
Fiero dash cut
CCIE:
--- Quote from: Sybersonix on June 10, 2016, 09:55:50 PM ---im ready to make my purchase of package you put together for me with cf panel, ty,Patrick
--- End quote ---
Patrick,
Are you ever going to pay me for the parts you purchased a while back?
Sybersonix:
im ready to make my purchase of package you put together for me with cf panel, ty,Patrick
CCIE:
Also don't forget the defroster vents.......
Diablo 60 uses a set of 3 long defroster vents.
I have them, I also have the round vents without the bull if any one has a need for them.
If you are doing Diablo build I have bunch of stuff that are exact copy of OEM and bunch of OEM parts for the interior.
If any one wants to trade work on my car for parts.... I am all over it. I am in Central Ohio.
CCIE
yusha_2000@yahoo.com
CCIE
01Lambiero:
If you are budget conscious, the vent outlets are available (oem but without the bull) from the Prevost bus company in Canada. Another option is the a/c vent from a Honda Acura. Mitsubishi Eclipse has one also but I'm not sure of the diameter. Mods to each will be required to work (as always). Jim
01Lambiero:
Heater and ductwork for defrosters. The heater area has to be trimmed to get the body to set lower. Some builders have glassed a low profile duct on the bottom of the upper dash panel to route the air flow to the outlets. Outlets similar to the OEM without the bull are available from a bus company.
Navigation
[0] Message Index
[#] Next page
Go to full version