Author Topic: Automatic window roll down  (Read 1899 times)

msaby

  • Trade Count: (0)
  • Jr. Member
  • **
  • Posts: 31
  • Liked: 3
  • Member Rating Points: +3/-0
Re: Automatich window roll down
« Reply #3 on: October 16, 2012, 12:39:54 PM »
It rolls the window down because it is a diablo roadster.  The lambo door will not open with the roof on unless the window drops about 2inches.

madmods

  • Trade Count: (0)
  • Full Member
  • ***
  • Posts: 146
  • Liked: 17
  • Member Rating Points: +1/-0
Re: Automatich window roll down
« Reply #2 on: October 16, 2012, 10:30:47 AM »
I would run them both seperate. Rolling down the window shouldn't trigger the door to open. Look at autoloc for their universal window kits. That what I used in the vendetta.
Keep dreaming-I'm sweating, glassing, welding and building every night!
Gagliardi Vendetta
Vetter Carrera Gt
Vetter Lp 640

msaby

  • Trade Count: (0)
  • Jr. Member
  • **
  • Posts: 31
  • Liked: 3
  • Member Rating Points: +3/-0
Automatic window roll down
« Reply #1 on: October 14, 2012, 07:39:22 PM »
I thought I would try and explain how I built my power window roll down.  It is a very simple setup using common relays and a few other components.  I am building a Diablo roadster using the Fiero power window setup.  I have had this setup working in my car for over a year now, so I haven’t found any major flaws  yet.  I used many of the relay wiring diagrams from the www.12volt.com website. I’m sure someone could build a better setup but this worked for me.
The system will allow the window to drop about 2 inches and then trigger the door to open.  Once the door is open the window can’t roll up unless the door is completely shut.  Even if the ignition key is on.  When the door is locked with the key, the system will roll up both windows and lock the doors.  The door can be locked or unlocked from either door.
The parts required are as follows:
13    30amp relays
4   diodes
1   Capacitor
1   528T
10   Micro switches
2   heavy duty push button switches

This is where the components are being used.
5 relays are used for both power windows
2 relays are used for the door actuators
6 relays are used for the door lock and window roll-up
4 diode are used for the window roll up
1 528T is used to roll-up the windows
2 micro switches are used for the door locks
2 micro switches are used for the inside door handles
4 micro switches are used to limit the travel of the window (limit switch)
2 micro switches are used to trigger the roll down.
2 micro switches are used to ensure the door is completely closed.
2 Heavy duty push button switches used for the outside door buttons.

Please be patient I will try and provide pictures and an explanation as I go.  If you have any questions I will try my best to explain it.
« Last Edit: October 16, 2012, 01:00:36 PM by msaby »