How To - Tips > Steering / Suspension

Which Axles?

<< < (5/5)

01Lambiero:
Have you checked all of your other posts about your bad axle???  It's like deja vu all over again, again.
01

★Murci-Me★:
O   M   G, AGAIN??? This is the 3rd thread about the SAME THING (Need help, what half shaft, and now "which axels"!!!) Somebody ban this moron already.

Ccemn1:
I recently purchased an IFG Diablo on a Fiero Base vehicle, 2.8 V-6 and 5 speed transaxel.
In going over it, I discovered I needed new drivers side rear wheel bearings and a half shaft. I purchased both online, but when delivered, it was immediately apparent that the stock Fiero half shaft was too short. I was told this car had the anti-bump steer package, and apparently a wider rear suspension, because there don't seem to be any wheel spacers being used. The distance from the Trans to the inside of the bearing hub is about 16".
Can anyone give me a clue as to what half shafts I should be using?
Thank you.

Navigation

[0] Message Index

[*] Previous page