How To - Tips > Fiberglass & Paint

Two tone paint question

(1/2) > >>

eddie:
Yes it would
How ever since you don’t use it everyday as some shop
What would it be cheaper for small job
15$ semi gloss can or may clear package ?
I’m not sure if you can buy just a quart pkg?
Or whole gallon pkg. and it’s not cheap.
On other note you can get aftermarket additive to kill the sheen
But truthfully I never tried

AdrianBurton:
question:  Wouldn't a satin clear give the same result?

eddie:
Neil too late  lol, whole  car is wired , lights, switches, etc all test and pre fit. only I left was  wiper motor I thought it'll be ez later on. was I ever  wrong . getting to old I guess
look Jim's Dinner car I painted ,not in my booth someone else shop. time flies

Neils88:
Eddie...maybe I should wire your car in exchange for you painting mine...  ::toothy

I wish I had a full paint booth. Unfortunately, I'll have to wait until we get our new house built for me to have a dedicated space for painting. And that is on hold due to the pandemic. I'll have to make do with what I have for now.

Thanks for your advice, Eddie.

eddie:
funny I just did a bumper B/C W/B and one small part flat . again  flat rate hack . that part was sprayed  with water base, then to get that flat look I use lacquer spray to protect the base and 3-4 coats its flat and fast, now to do next  job .but large panels or multi section use PPG mat gloss

Navigation

[0] Message Index

[#] Next page