Build Diaries > Aventador

Lambobuilder's Aventador Build

<< < (2/6) > >>

lambobuilder:
Latest video on detail of how I did wing flaps, side vents and a full walk around at the end. https://youtu.be/2K9-8TtNvIw

lambobuilder:
Mounted the rear bumper and added shocks to deck lid. https://youtu.be/UfHaRo991ZQ

lambobuilder:

--- Quote from: 01Lambiero on December 20, 2021, 11:23:17 PM ---Hi Dale,  Is there any process that might include scribe cutting on the underside of the warped corners and heating to bend as necessary or is it cut and glass time as required?  Have you checked with the manufacture for any help as it appears that the panel needed to be put in a fixture and clamped to prevent warpage during the cure process?  On the other hand, you could just dura-glas the top to a flat surface mate to the adjacent panel.

01

--- End quote ---
Did not check with Dur-A-Flex on warpage. It's possible that when I got part that It was fine and warped in my storage. I should have tried the heat process as have done that before but it's been a while. Still a little more tweaking required but that's always going to be the case. Thanks for suggestion.

01Lambiero:
Hi Dale,  Is there any process that might include scribe cutting on the underside of the warped corners and heating to bend as necessary or is it cut and glass time as required?  Have you checked with the manufacture for any help as it appears that the panel needed to be put in a fixture and clamped to prevent warpage during the cure process?  On the other hand, you could just dura-glas the top to a flat surface mate to the adjacent panel.

01

lambobuilder:
Added new video on how I did rough install of rear deck lid and front trunk. https://www.youtube.com/watch?v=Ae0NDGbYKkE

Navigation

[0] Message Index

[#] Next page

[*] Previous page