Build Diaries > Aventador

Aventador wheels with C6 hubs

(1/2) > >>

lambobuilder:
Charley's article. https://lambobuilder.com/aventador/AxleDelemaSolved.pdf
and his YouTube that goes over his solution https://www.youtube.com/watch?v=vfBC2UFBQvM&list=TLPQMTAwNTIwMjITu5PF7JRCtw&index=1

LP700-4:
Thank you for the information. I just received my OEM wheels yesterday, they are the same as yours only in black. The front on these are the same 5 x 112mm as yours.

I did a little research and there are a lot of cars that use the 112 bolt pattern. Wonder what is the best way to determine if any fit the C5/C6 front spindles?? 

i do remember that Charlie had posted something about the lexus axle. For some reason I thought I remembered that it fit the corvette hubs, getting old so my memory might not be all that great anymore. I'll have to find that post to see if he gives the hub part number for the lexus axle and 120mm rear bolt pattern or if it fit the C6 version.

By the way, I have watched all your videos several times. lots of amazing information there and a great build! I need to create a youtube account so I can subscribe.

I just finished a custom chassis design that fits the aventador and uses the C6 suspension without the cradles. Waiting on quotes for the metal to come in now so I can purchase the metal needed. Still deciding if I want to do a photo build diary or a video like yours...

For my build I am using OEM panels or fiberglass copies of OEM panels. Still missing a few.

lambobuilder:
Because I am using the NAERC plans for my chassis, The front suspension called for the S10 hubs which I believe were standard Chevy bolt pattern. I had already purchased OEM wheels. Hindsight, should have looked for hubs with 5 x 112 pattern that fit Corvette spindles. My OEM wheels 5 x 112 front and 5 x 120 rear. I believe that is the only year (2012) where Lamborghini had different bolt pattern.  Because I am using the Lexus axles I was able to find a hub for the rear with that spline pattern that fits the hubs as well as bolts directly to my Audi Transaxle. My rear suspension is hand built. Covered in this YouTube video https://youtu.be/PPPyyzxz7q0

LP700-4:

--- Quote from: lambobuilder on May 05, 2022, 09:42:44 AM ---I redrilled my hubs to fit the 5 x 112 bolt pattern as well as milled out wheel to fit hub. Explained on my YouTube video. https://www.youtube.com/watch?v=uhnfu2T-nyU

--- End quote ---

Dale,
I see that you used the Acura front wheel hubs (HA590147) with the 120mm bolt pattern for the rear. Are these a direct bolt in to the C6 spindles or do they or the spindles need to be modified? This might be a better option than redrilling the rear C6 hubs

Thanks for the option for the front, I will have to decide if I want to go the adapter route or redrill the hubs and modify the front rims. Why did you use the S-10 hubs instead of the C6 hubs if you had to re-drill to 112mm either way? Cost of the hubs? Mine are from a low mileage C6 so I would hate to replace if I do not need to.


 

lambobuilder:
I redrilled my hubs to fit the 5 x 112 bolt pattern as well as milled out wheel to fit hub. Explained on my YouTube video. https://www.youtube.com/watch?v=uhnfu2T-nyU

Navigation

[0] Message Index

[#] Next page