For Sale / Wanted > Services

Aventador custom chassis drawings for 500 USD / 470 EUR

<< < (2/26) > >>

plans4sale:
 Attached here are a few pictures of my final design of the Govedo chassis and suspension. I still do improvements on some of the metal sheets on the floor, sides and rear firewall, this is why they are not yet present in the pictures. The weight* (approximate calculation in a 3d software based on steel weight 7800 kg per cubic meter) of the EU version of my chassis should be as follows:

- Bare chassis with no suspension and metal sheets: 274 kg (604 lbs);
- Chassis with partial metal sheets (as shown in the pictures), suspension arms and wheel hubs: 381 kg (840 lbs);
- Chassis with full metal sheets, suspension arms and wheel hubs: 395 kg (871 lbs). Optionally, if 1 mm metal sheet in certain areas is replaced with 2 mm one, for extra frontal crash protection, the weight goes up to 430 kg (948 lbs).

 For comparison, by using the same formula for calculation, a steel replica Diablo (NAERC) chassis with the roll-cage, suspension, 2/3 of the central tunnel, and 1/2 of the metal sheets missing appears to weight about 327 kg (721 lbs). It's said to be 394 kg (868.43 lbs) with suspension.


PS: Full resolution images (about 450 kB each):
http://i.imgur.com/gMgSc6v.png
http://i.imgur.com/YkOLuG7.png
http://i.imgur.com/TRrWWXJ.png
http://i.imgur.com/h5hSX3c.png

ncrazyballa:
looks okay.

76mx:
Those viewings must have happened while the pictures were temporarily thrown haphazard into a parallel universe. Good thing it did not upset the time and space continueum and suck us all in.

plans4sale:
 
--- Quote from: 76mx on January 26, 2016, 08:32:01 PM ---Not sure what is happening with these pics. First they won't post ,now they post twice.

--- End quote ---
They all appeared as "viewed 27 times" right after the upload. ::beers

76mx:
Not sure what is happening with these pics. First they won't post ,now they post twice.

Navigation

[0] Message Index

[#] Next page

[*] Previous page