Wanted to put additional clear on the REDO. But before I did that

2 body lines that were bugging on me, the top inside straight body line that was out by 1/16" for about 6 inches
And a 1/8" or less indentation on the drivers qtr. lower body line.

There were also 6-7 burn throughs in the clear that needed to be fixed.

Sand the clear.

Using a Iwata Eclipse HP-CS Airbrush, I applied very light base coat as to not cause lift or wrinkling, pulled the masking tape to blend, then used my sun gun to check for coverage, covered with clear. worked great!

Then I attacked the upper qtr to fix the line and did the body work on the lower line.

Primed the area, last night.  Now to sand for base

Even though the paint going on the REDO is from the original batch I will blend the base into the driver's door and down the quarter panel


 

Uninstalled the interior.

On to the next to-do!

Wow, simply WOW!

Here is a link to the REDOs interior 

7 Austrian hides with a bit leftover.  It's a sustainable product !

https://www.youtube.com/watch?v=4OpF3car2xA

The OE sunglass upper console was not staying latched.

Part 410867543A  hook mechanism was broken.  57$

After I purchased the OE hook Mech.  Saw an item on ebay that looks similar.     $7 for 4    figures.  Not sure if they are the same size or not 

The little metal clip part 418868847  is 319$  ....dont loose it 

Also the plastic flocked tray was cracked and had to use a bit of super glue to fix it.