Purple People Eater LP670 SV Build!!!

[Purple LP670 SV]

Here is a little better video of my 3800SC running!!! 

https://www.youtube.com/watch?v=mPrxtCtliFU

[Purple LP670 SV]

Thanks to Mr. Butler, I now have my ballasts! Only things I need to complete my headlights now are buckets and lenses!!! 

[Purple LP670 SV]

https://www.youtube.com/watch?v=TGITlWYySC4&feature=youtube_gdata_player

Here is a short you tube clip of my engine starting for the first time! Open headers and a mostly broken phone didn't really do it justice! But it was deafening!!!

[Purple LP670 SV]

Purdy Vents!

[Purple LP670 SV]

Yep! The wiring harness and computer were made and reprogrammed accordingly by Dan Fiero Flyer! I was just unsure as to what I was missing when it came to injector wiring!

[eddie]

did you get the ECM re program? you need to take off Auto, and other stuff.

[Purple LP670 SV]

It's a getrag 5spd! I still need to hook up the shift linkages!

[eddie]

do you run auto or stick??

[Purple LP670 SV]

Thanks for all the suggestions! I ended up having to cut a portion of the harness loom to determine which wire he had dumped all 6 pink injector wires into! Then for the mean time hotwire them to a remote wire! I will eventually give it it's own fuse but for now it runs! Thanks again!!!     

[eddie]

if you dont find the way to work ask here
https://www.facebook.com/groups/3800SC.3800.Fiero.Swap.Page/?fref=nf

[Robert]

Purple, you need a noid light to visually verify if the injectors firing. I bought a set of noid lights at Auto Zone a few years back.  If the ecm does not see oil pressure, the injectors will not fire. Verify your oil pressure switch, and the wires. Make sure one side of the switch is getting voltage. Also, make sure you have good grounds!

[eddie]

if your ecm is like that I have all pins wiring blue and white which for. that little cover on top is your chip ,easy to replace with upgrade 
white pig tail
#22,24,26,28,30,32, injectors  10amp fused power

[Tusabes]

Try what the guy on mm said then
Post results

[String]

do you have crankshaft and camshaft sensors - (for engine position), also what air measurement system does the engine use - ( for fuel quantity calculation) , and finally do you have a wiring diagram for the ecu - to determine which pin(s) should be powered by the aforementioned fusebox and of course which should be grounded.
From what you have described so far , covering these points should get towards a running engine.

[Purple LP670 SV]

The engine and ecm are both from a 98 regal! Everything is working perfectly, if I remove a plug and squirt fuel into the cylinder it fires right up then dies instantly! The fact that my Fiero fuse box is not wired for injection makes me wonder! I am just hoping someone out there has had a similar problem and what there solution was!