LamboClone - The Premier Site for Lamborghini Replica Builders
How To - Tips => Doors => Topic started by: lambogarage on November 11, 2019, 11:52:25 PM
-
Hi, does anybody have Original Diablo/Murci Door hinges, I need some measurements.
Thanks in advance.
-
Here are the dimensions from an oem hinge. 01
-
I made my own hinges using 1/4" steel at the dimensions shown below. My first set utilized the brass bushings and later I used 3/8" needle bearings. 01
-
What is the width fron Side to side outside the pin area including the bushings? What are the sizes of the 2 tubing pieces where the Bushing goes in?
-
I believe that the OEM bushings are pressed in from the outside. The diameter depends on whether you are using 3/8" dia. hinge pin (drill rod). They will have to be reamed to a press fit to the bore. Use oil lite bushings. If you press them in from the inside you will not need a washer on the inside. The inner section is drilled for the 3/8" pin with a set screw to hold it in place. 01