How To - Tips > Fiberglass & Paint
Two tone paint question
eddie:
Yes it would
How ever since you don’t use it everyday as some shop
What would it be cheaper for small job
15$ semi gloss can or may clear package ?
I’m not sure if you can buy just a quart pkg?
Or whole gallon pkg. and it’s not cheap.
On other note you can get aftermarket additive to kill the sheen
But truthfully I never tried
AdrianBurton:
question: Wouldn't a satin clear give the same result?
eddie:
Neil too late lol, whole car is wired , lights, switches, etc all test and pre fit. only I left was wiper motor I thought it'll be ez later on. was I ever wrong . getting to old I guess
look Jim's Dinner car I painted ,not in my booth someone else shop. time flies
Neils88:
Eddie...maybe I should wire your car in exchange for you painting mine... ::toothy
I wish I had a full paint booth. Unfortunately, I'll have to wait until we get our new house built for me to have a dedicated space for painting. And that is on hold due to the pandemic. I'll have to make do with what I have for now.
Thanks for your advice, Eddie.
eddie:
funny I just did a bumper B/C W/B and one small part flat . again flat rate hack . that part was sprayed with water base, then to get that flat look I use lacquer spray to protect the base and 3-4 coats its flat and fast, now to do next job .but large panels or multi section use PPG mat gloss
Navigation
[0] Message Index
[#] Next page
Go to full version