LamboClone - The Premier Site for Lamborghini Replica Builders
Misc. Tech Drawings / Manuals => Technical Drawings => Topic started by: No Bull on December 09, 2013, 08:12:38 PM
-
Thanks to String for providing these in another thread.
Use Sketchup to open these.
Chris
-
Here are a couple pictures of the one I have from a burnt Murci.
-
is there any way to flatten any of the separate pieces in sketchup? like undo all the bends?
-
is there any way to flatten any of the separate pieces in sketchup? like undo all the bends?
I suck at sketchup but I imported it into Revit and I am working on that. I'll see if I can get some templates up today or tomorrow.
-
Flattened ! , of course ..... thanks to those who pointed this out.
Oooh , new smileys W:)
-
:occasion ::thumbup
-
Here are some PDF's, they are printed on 11x17 size paper. The measurements on there have been rounded to the nearest 1/8" since String's drawings where in mm. and I converted them.
Thanks String for providing those sketches :notworthy
-
that helps thanks guys! :santa
Anyone know what kind of springs are needed? It looks like it holds the lid closed until it's pulled back then it holds it open.
-
here's an oem pic for reference (http://buyersguide.caranddriver.com/media/eVox/stills_0640/5397/5397_st0640_061.jpg)