LamboClone - The Premier Site for Lamborghini Replica Builders
How To - Tips => Frame => Topic started by: solrac on May 18, 2013, 02:16:32 PM
-
Today i bought my metal to start the subframe and all the reinforcements.
I got 2x3- 1/8 thick. I will be welding it parallel to the bottom door jam.
i can weld from the top part.. but what about the bottom part.
my questions is. whats a good technic or how do u weld from bottom to up?
-
(http://i198.photobucket.com/albums/aa222/juanseefoo/reventon/C34C1D35-A889-4B60-8A4D-54F7D7729B4E-10819-0000067B4B4CBC57.jpg)
trim the outer wall up flush on the rocker sill ,"B" post & "A" post where the door bolt too
(http://i18.photobucket.com/albums/b138/italianknightrider/LPTub-1.jpg) (http://s18.photobucket.com/user/italianknightrider/media/LPTub-1.jpg.html)
(http://i18.photobucket.com/albums/b138/italianknightrider/italianknightriders%20album%202/LPHINGEBEAMREWORKFORLOWEREDFRONTENDSTXT2.jpg) (http://s18.photobucket.com/user/italianknightrider/media/italianknightriders%20album%202/LPHINGEBEAMREWORKFORLOWEREDFRONTENDSTXT2.jpg.html)
-
Thanks but how do I weld the bottom part of the support metal?
I weld the top part but what about the bottom??
-
stitch weld from the bottom edge ,(remember to remove/grind away the zinc coating & rust proof after the welds ) we have a car lift in one shop and 4 Rhino Auto zone drive on stands $50.00 a pair very handy ....sometime i jack the car up and put the stands under the wheels
-
Today i bought my metal to start the subframe and all the reinforcements.
I got 2x3- 1/8 thick. I will be welding it parallel to the bottom door jam.
i can weld from the top part.. but what about the bottom part.
my questions is. whats a good technic or how do u weld from bottom to up?
Verticle up mig welding is not easy, you should have many years of welding experience. Go verticle down using a circle motion, about the size of a large pea. The circle method will ensure that you have penetration on both pieces of metal your welding. I have sunday off, I'll try to make time to weld a circle verticle down weld and post it.
-
where did you pick up your framing material - round and square atock?
Thanks!
-
I google " metal supplier " I found local companies who supplied it. I bought 2x3 for my sub frame. There is this place called bobco metals in Los Angeles.
-
where did you pick up your framing material - round and square atock?
Thanks!
I answered your question in Pedro's NEARC build thread....
-
Thank you both SchulzeA and solrac !