LamboClone - The Premier Site for Lamborghini Replica Builders
How To - Tips => Steering / Suspension => Topic started by: norcaldiablo on April 07, 2013, 05:55:40 PM
-
I am ready to start on my brakes.
I have 13" rotors on all corners.
What proportioning valve are you using for your setups?
I have power brakes and a custom chassis (not Fiero).
Also, what size lines to the front and rear brakes?
Any special tricks?
Thanks
-
I used a wilwood proportioning valve with 13" brakes
-
An adjustable proportioning valve will be needed in the rear line. 3/16 brake line should be fine. Sometimes I run 1/4 back from the master cylinder to a T where the line splits to the each side for the rear brakes. I use 3/16 from the T to each wheel.