LamboClone - The Premier Site for Lamborghini Replica Builders
How To - Tips => Frame => Topic started by: bierhanzel on October 11, 2012, 08:34:53 AM
-
Hello all. I need advice. How to involve the brakes to individual wheels. Without ABS. Where To Put Brake force Distribution (front% / rear %). And also the correct placement of tubes in the frame. And most of your experience and pics in your tube frame :-)
I have 4-piston calipers on the front with one output, on the rear 4-piston calipers with two output (and I must make a hydraulic handbrake)
My brake cylinder with booster ( ALFA ROMEO 156) have 4 output possible
I believe in the beneficial debate :-)
-
I might not be a big help on this but I think you need a distribution block, they are usually located right under the master cylinder and your calipers have input's not outputs, usually only 1 per caliper, ive never seen a caliper with 2 ::scratch, my advise would be to block off the 2nd holes on the calipers.?
-
this is utter nonsense?
(http://img11.rajce.idnes.cz/d1103/7/7180/7180210_be94c936bf45c7d8d5470181cca39b51/images/nesmysl.jpg?ver=2)
-
I might not be a big help on this but I think you need a distribution block, they are usually located right under the master cylinder and your calipers have input's not outputs, usually only 1 per caliper, ive never seen a caliper with 2 ::scratch, my advise would be to block off the 2nd holes on the calipers.?
There is no problem to connect the rear inputs, there are jumpers. But I also to function properly handbrake
-
Ya I see now, your hand brake is hydraulic and not cable driven ::study. You have to have a Proportion/distribution block after the master cylinder. They come in adjustable also! I am assuming you will be running disk breaks in the rear?