LamboClone - The Premier Site for Lamborghini Replica Builders
For Sale / Wanted => Replica / Modified Parts For Sale => Topic started by: jb1 on April 13, 2012, 02:27:14 AM
-
I had 1 person from another forum ask about a set after I sold out of the first and intended only run, but I am working on the rears now (mainly just trying find time to get done) and wondered if anyone interested in complete set front and rear, the rear uses a 91 transport van steering knuckle machined to accept the s10 4wd hub bearing and uses the outer cv joint from the s10, I could offer the rings hubs and steering knuckles and let you source the other parts or I could put together a complete kit,,,, the front is $200 with all new bearings and seals , the rear is looking near $350-375 with new hub bearing and cv joint, both could be found cheaper used..
I am not really making any money off these by the time I pay someone else to do the machine work, So I do not want to make 2-3 sets and set on them unless there is some interest, I have to have 2 rear sets made thought I would check befor I order the steering knuckles... the front hubs and steering knuckles themselves are used but all bearings seals cv joint etc is new..
(http://i2.photobucket.com/albums/y6/JB1/DSC01914.jpg)
the inner bearing stop has been machined .125 deeper to allow the hub to fit all the way back on the spindle
(http://i2.photobucket.com/albums/y6/JB1/DSC01916.jpg)
the new seal ring has to be pressed over the old seal surface
(http://i2.photobucket.com/albums/y6/JB1/DSC01919.jpg)
.032 spacer to take up the difference of the id of the outer bearing and the spindle.
(http://i2.photobucket.com/albums/y6/JB1/DSC01920.jpg)
(http://i2.photobucket.com/albums/y6/JB1/DSC01913.jpg)
everything assembled.
-
I might be interested in something like this however my Fiero is a 88. I am having trouble finding CV axles to fit my SC3800 swap. Would a kit like this make that issue any easier?
-
it only works on the 84-87, 88 has a total different suspension. really all this conversion does is change the lug pattern and adds larger wheel bearings. As far as your axle issue goes I believe you going to end up having to buy a custom axle, I am interested in what you end up finding because I will eventually order the wiide track for HT as well...