Misc. Tech Drawings / Manuals > Technical Drawings
Front Bonnet Hinges
Tallon:
uh.. Maybe... I know I assembled them wrong more than 10x LOL
Edit:
Ok I see, easy fix. I swapped them, it didn't really change functionality since the holes line up either way
Digibeam:
I hate to bring this up, but looking at them, isnt the lower piece that would bolt onto the fender area...on upside down?
SchulzeA:
It's not a 70's Buick hood lol. How much could a fiberglass hood possibly weigh?
Mild steel usually has about .4% carbon and cannot be hardened. I've tried against what heat treatment books say but they are defiantly right.
Tallon:
I didn't think of that until I made them but since it's low carbon I'm not sure how much they could be hardened anyway by quenching
Maybe it would be worth it to "treat" certain spots?
01Lambiero:
Did you have the steel heat-treated to stiffen them up?
Jim
Navigation
[0] Message Index
[#] Next page
Go to full version