How To - Tips > Bat Wings & Spoilers

Project Chaos - Bat Wings

(1/2) > >>

usmc_butler:
X2 add me to the list... I'm already getting enough stuff might as well add this to the list ;D

Tallon:
Mike I'd be interested in the side moulds I'm surprised no one else said anything but I didn't see the post until now for some reason.

Seems easy enough with the moulds, if the mould has the shape of the the top of the wing I would just need to set it on and add the glass underneath.

jb1:
personally I believe it would  sale better ( or at least I would  prefer to buy ) a complete  set of bat wings....   for the  probable cost difference  seems it would be better  to have  a  whole  set instead of  piecing them together..  what would you charge for a complete of bat wings vs. just the sides?

Murci-Me:
I can make moulds of my batwing sides if anybody wants them. The sides that Rob sells (and Joe) are actually moulded from my original sides, but the curvature is wrong, and so is the front profile.
I will post a video of my batwings working, so you guys can see how the side curve matches the pocket recess. When the wing is down, there is a 3/16" gap between the body and the wing. When the wing is up, there is a 3/16" gap between the side and body. The wing sides are 5" long.
I can either make moulds of the sides, or make a mould of each complete wing and just sell wing sets. Which would you guys want?
If I made a mould of the sides, they can be used by one member, then shipped to the next, then the next and so on. To make a good mould that would produce about 35 sides each would cost about $40ea. ($80/pair).

Tallon:
Hm I have the supposedly low quality 'car kit inc' body and my batwing curvature is fine, and they have their bodies laying out in the sun to cure not supported by anything

Navigation

[0] Message Index

[#] Next page