« previous next »
Pages: [1]

Author Topic: Proportioning valve  (Read 1573 times)

aeauto

  • Trade Count: (0)
  • Full Member
  • ***
  • Posts: 124
  • Liked: 33
  • Member Rating Points: +1/-0
Re: Proportioning valve
« Reply #3 on: April 07, 2013, 07:40:47 PM »
An adjustable proportioning valve will be needed in the rear line.  3/16 brake line should be fine.  Sometimes I run 1/4 back from the master cylinder to a T where the line splits to the each side for the rear brakes.  I use 3/16 from the T to each wheel.
Logged

rodrieguz

  • Trade Count: (+3)
  • Full Member
  • ***
  • Posts: 200
  • Liked: 77
  • Member Rating Points: +3/-0
Re: Proportioning valve
« Reply #2 on: April 07, 2013, 06:56:44 PM »
I used a wilwood proportioning valve with 13" brakes
Logged

norcaldiablo

  • Trade Count: (0)
  • Jr. Member
  • **
  • Posts: 44
  • Liked: 0
  • Member Rating Points: +0/-0
Proportioning valve
« Reply #1 on: April 07, 2013, 05:55:40 PM »
I am ready to start on my brakes.

I have 13" rotors on all corners.

What proportioning valve are you using for your setups?

I have power brakes and a custom chassis (not Fiero).

Also, what size lines to the front and rear brakes?

Any special tricks?

Thanks

Logged
Pages: [1]
« previous next »