« previous next »
Pages: [1]

Author Topic: LED's?  (Read 1384 times)

76mx

  • Trade Count: (+2)
  • Hero Member
  • *****
  • Posts: 768
  • Liked: 358
  • Member Rating Points: +16/-0
Re: LED's?
« Reply #3 on: September 28, 2017, 06:19:48 PM »
There are going to be two flashers, one for the signals and one for the hazard lights (even though the lights are the same ones). I think Thumper's manual is going to say that both of them are on the fusebox. DelCity #73970 or #73975, they just plug in.
Logged

Thumper

  • Trade Count: (0)
  • Full Member
  • ***
  • Posts: 90
  • Liked: 31
  • Member Rating Points: +1/-0
Re: LED's?
« Reply #2 on: September 28, 2017, 02:45:37 PM »
I'd think you will need an LED flasher as it's a load resistance thing.  Don't quote me on that, but I've run across a few people that had this issue while swapping to LED's (but I'm not 100% sure what they did to fix it).  Maybe someone else can chime in for 2nd opinion?  As for the location, check here...
http://www.fiero.nl/forum/Archives/Archive-000001/HTML/20050119-2-053838.html
Logged

Ccemn1

  • Trade Count: (0)
  • Sr. Member
  • ****
  • Posts: 254
  • Liked: 22
  • Member Rating Points: +1/-0
LED's?
« Reply #1 on: September 28, 2017, 02:26:09 PM »
I recently purchased a Fiero based, IFG Diablo, and I'm replacing the lights with LED's. I did the rear brake & tail lights first, with no problems.
When I replaced the front turn signal/parking lights with the 1157 equivalent in LED's, the turn signals don't work anymore, front, or back.
When I put the incandescents back in the front, everything works fine again.
I'm guessing I need to use a different LED compatible flasher or something? I've tried to figure out where the flasher is, but it's darn near silent & can't find it?
Any tips would be greatly appreciated.
Logged
Pages: [1]
« previous next »