Murci Me, THANK YOU very much, I do believe my paddles will flex to much they seem to be fiberglass copies I thought they might be ok to bolt to a plate system did not figure there would be much pressure.
In you video you stated your paddle system is available? from you? how much? I have the controller and most of the programing figured out, mine as well will go into sleep mode after a few secs , pull a lever 1 time to wake up then again to shift .
I am working on making where you can not shift from d to r,n or park while car is in motion,thinking about making 1 2 3 (4t65-ehd) all electrical and not use the actuator but actually just trigger the shift relays from the arduino so you can manually shift and not worry about any delay with the actuator, also going to play with lcd to do odometer and gear position,,
when I complete I intend to post the code and parts so others can simply assemble the parts and download the code.... ( not looking to make money off this, plus would not want any liability) with the Arduino MEGA , actuator and motor driver I am around $200 , lcd will run $10-20 so minus the paddle set up under $250
