Lamborghini Murcielago GT1 World Series Replica

[italianknightrider]

5 stud corvette bolt pattern ...only make 1

[Peggyontherunireland]

@ italianknightrider - i think the diameter is 400mm i double check tomorrow for you. I would need a bolt pattern as the alloys that i am using on my Labo are off a corvete the rear is 5 stud and the front is 4 stud. If you can get me the correct stud pattern and e-mail it to me i can make you one or do you just want one th same as i have ??

[italianknightrider]

what is the Diameter , make me one an i will do the other 3 how much

[Peggyontherunireland]

Got the fake disk cut out i done this all by hand no machines used here

The drill/groove disk look im going for

All primed ready for painting

[Peggyontherunireland]

Ok my last disks were a tad bit to heavy to fit on the wheel hubs so i am making new ones out or aluminum
Here is the template

Template and then i will drill the holes for the drill & grove look a like

The old caliper

Got the rear painted today



All the masking removed

[Peggyontherunireland]

Spent a bit on the rear here it is in primer this was a in a bad way as the fiberglass was very poorly laid up



A few pin hole can only be seen when primer is painted on re-fillered and left to dry

[Peggyontherunireland]

Got the lenses on the car and all the lights are working

[Peggyontherunireland]

Hi Lads sorry about that i have been up to my eyes in work on the Lambo will put up a thread in the for sale section

[usmc_butler]

Hey why don't you put your Lamborghini windscreen stickers for sale on here?! Put me down for a few sets



BTW Car is looking good as always! Cant wait to see the vehicle wrap 



Dustin

[Peggyontherunireland]

Been sanding to get the door gaps



Indicators working  videos for ya

The rear lights working

[Peggyontherunireland]

Headlight surround sprayed



Passenger side headlight being set in place

Drivers door cut out

Passenger side door cut out

Gap re-filled just need to be sanded

Headlight lens in just a bit of snagging left to do

[Peggyontherunireland]

Collected this back from the company that carbon fibered it
Petrol cap section

Closing panel on the passenger side

[usmc_butler]

LOVE IT ! Just keep the Acid in the batteries 

[Peggyontherunireland]

Door cut out

A bit of weight added to keep the lens in position

Door cut out just have to finish the sills

Passenger side headlight in

[Peggyontherunireland]

@ onewickedsvt - yes i did use bottle caps and they did the job perfect 

@usmc_butler - cheers mate