Anyone interested in using a 944 transmission?

[aeauto]

It can be put together, the question is how much interest is there?  I am not going to make any parts until I have an order.  The fact that the plate is 2 1/2 inches thick might be a problem for fitting for some builders.  This design was done by someone else and I haven't seen all the details.  It may be possible to make the plate thinner but I would have to do some research on that.

[AdrianBurton]

if you can put that together that would be great, the 944 box is stronger than the 016

[aeauto]

Different splines.  I think 10.  He is using a Chrysler disc.  I think also Ford Ranger fits.

[AdrianBurton]

what about the input shaft? is it splined the same as say, an audi or other Porsche?

[Graeme Stebbing]

I recon he could be right I have one in the shed also the shifter rod went through where the clutch slave would go on a 016 so should not be that hard to adapt

[aeauto]

He says hydraulic throw out bearing with easy to install tube for it to ride on.  He hasn't sent me any photos yet.

[AdrianBurton]

what is he doing for the clutch?? the 944 box doesnt have provisions for on in it

[aeauto]

I have someone who says he has designed an adapter to make this work with minimal mods to the transmission.  Uses stock flywheel and clutch parts.  If I get any interest I will pursue it.  Anyone?