Texas Reventon Build

[Texas]

Hey fellas. Made a little progress. I normally take lots of pictures but I was too focused on the tasks at hand. Big thanks to USMC-Butler for driving down and helping with the stretch . Stripping the dash sucks.

[SchulzeA]

 

[Texas]

Just awesome, the fit, the finnish, the lines, everything just turned out so clean. Proof that good work pays off. Astonishing 

Too kind Sir. Thank you.

[usmc_butler]

Just awesome, the fit, the finnish, the lines, everything just turned out so clean. Proof that good work pays off. Astonishing 

[Texas]

Thanks. Same to you.

[solrac]

WOW texas.. i didnt realized it took soo much.. It is looking really good tho.. NICE WORK

[Texas]

Oh one in the dark.

[Texas]

Ok last round. So this is where I'm at currently and this is running one of the early versions of Solrac program but you get the idea of what it should look like. I am still working on the dividers. I will update when I get there. 

[Texas]

Second one! To attach the inside bezel sand with 36 grit paper clean and I used.... Panel bond  So it dries fast and I didn't get a pic of where I put the adhesive but I put a bead on both parts on the front and rear edge. 

[Texas]

First real part pulled.

[Texas]

More prep, primer, sanding, wax and then mold. Plug broke removing the mold.

[Texas]

An attempt to make a carbon pod. And starting the same process again on the inside.

[Texas]

Checking fitment.

[Texas]

And the top mold with a brace to keep it from sucking in. The first part pulled.

[Texas]

Some Finnish sanding waxing and mold release. You can see the underside is shaped so it fits right onto the dash with no gaps. Top side of the mold.